Tektronix TekConnect Probe Interface Module 80A03 Instrukcja Użytkownika Pobierz pdf (Strona 25)

Operating Basics

80A03 TekConnect Probe Interface Module Instruction Manual

Table 3: Recommended equipment for triggering setups (cont.)

To trigger only To trigger and view a signal

Compatible TekConnect probe.

See page 1.

Compatible TekConnect probe.

See page 1.

(1) SMA cable, 0.5 m

(3) SMA cables, 0. 5 m

Torque wrench, SMA 5/16, 8 in-lb Torque wrench, SMA 5/16, 8 in-lb

-- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- (1) 6 dB power di vider

Tektronix part number 174-1427-00.

Tektronix part number 015-0565-00.

To set up the TekConnect Probe Interface Module to trigger CSA8000 and

TDS8000 Series Oscilloscopes, do the following:

1. Remove the semi-rigid cable that connects the CH B TekConnect Probe

Interface Module to the sampling module. See Figure 8.

Figure 8: Removing the semi-rigid cable

2. Use a 0.5 m SMA cable to connect the CH B TekConnect Probe Interface

Module to the sampling oscilloscope trigger input (Trigger Direct or Trigger

Prescaled). S ee Figure 9 on page 16.

3. Attach the TekConnect measurement probe to CH A on the TekConnect

Probe Interface Module. S ee Figure 9.

4. Attach a TekConnect trigger probe to CH B on the TekConnect Probe

Interface Module. See F igure 9.

Triggering CSA8000 and

TDS8000 Series

Oscilloscopes

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 41 42

Brak uwag

Tektronix TekConnect Probe Interface Module 80A03 Instrukcja Użytkownika Strona 25